What are the correct cleaning methods for hot melt adhesives in life?

Hot melt adhesive is a kind of plastic adhesive. It is solid at room temperature. After heating and melting, it can be quickly bonded within a certain temperature range. Its physical state changes with temperature, but its chemical properties remain unchanged. It is non-toxic and tasteless, and belongs to environmental protection chemical products.

Because the product itself of hot melt adhesive is solid, it is easy to package, transport, store, and has the advantages of simple production process, high bonding strength and fast speed, etc., so if you need to clean up after using hot melt adhesive products in family life, you can Clean up with:

1. You can use alcohol to remove the hot melt adhesive, use anhydrous medical alcohol instead of industrial alcohol, drop the alcohol on the hot melt adhesive, or use a cotton swab dipped in some alcohol to apply it on the hot melt adhesive, wait for the hot melt adhesive to cure Then it can be easily peeled off.

2. Use wind oil on the hot melt adhesive, and repeatedly let the hot melt adhesive slowly dissolve. This method is safer and more environmentally friendly, but the speed is relatively slow.

3. You can put a small ice pack on the hot melt adhesive, wait quietly for a few minutes, and then buckle it down.

4. Or put the object with hot melt adhesive in the refrigerator for a while, and when you take it out, you can easily peel off the hot melt adhesive.

5. Heat it with hot water and an iron to soften it. If neither hot water nor an iron is available, it proves that the softening point of this hot melt adhesive is relatively high, so its cold resistance will be a little worse. So put it in an environment of about -15 degrees and it should fall off by itself.